Many electronic products have begun to focus on improving their waterproof levels. In order to adapt to the constant changes in the market, the waterproof level of some electronic products has been upgraded from IPX34 to IPX56, which also indicates that the electronic products can adapt to more severe natural environments and spraying.
Various types of flushing testers have also appeared frequently. In order to meet the requirements of different customers, flushing testers can be divided into three categories: open, manual, and swing. The open type is suitable for the spray-proof test of large specimens, the manual type is suitable for the spray-proof test of small specimens, and the swing type is suitable for the spray-proof test of medium or long specimens.
No matter what kind of flushing tester, there will always be some minor problems during use. According to the feedback from the after-sales service department, it is found that the problem of the flushing tester not starting is raised more frequently. After analysis and processing by after-sales engineers, the editor summarizes the following points here for your reference.
1. The external power supply of the flushing tester is not connected correctly, causing the power supply to not start.
Solution: According to the water and electricity installation video provided by Yuexin, the three-phase five-wire of the flushing test machine can be connected according to the standard requirements.
2. After the power of the flushing test machine is turned on, it will not start without electricity.
Solution: We have installed a leakage protection switch on the back of the flushing test machine. Because it will be closed before leaving the factory, please turn it on manually before testing.
3. When the flushing test machine is tested, the water pump does not work, there is no water, and it does not start when the switch is clicked.
Solution: After the flushing test machine is emptied of water, residual air will enter the water pump. Please open the exhaust hole behind the flushing test machine.
4. After the flushing test machine is turned on, there is no water from the spray gun.
Solution: When the flushing test machine leaves the factory, the flow meter of IPX5/IPX6 will be adjusted to 0, so the flow meter must be turned on synchronously during the test.
The above are the reasons and solutions for various flushing test machines not starting. If you encounter other problems, Yuexin After-sales Service Department is ready to solve them for you.
Yuexin-focuses on the research and development and production of rain test chambers, and looks forward to every communication with you.
This article is an original article of Guangzhou Yuexin Testing Equipment Co., Ltd. and may not be reproduced without permission.
Your message must be between 20-3,000 characters!
