Many products in various industries now need to be tested for waterproof performance, such as drones, tablets, automotive motors, outdoor lamps, household appliances, mobile phones, etc.
Then the company chooses the appropriate water spray test equipment according to the product specifications, size, appearance, waterproof level, site, etc. However, after choosing the water spray test equipment, pay attention to the following points, otherwise it may not be used.
1. Water source, power supply: Generally, the water inlet of the water spray test equipment is a 4-point interface, and it is randomly equipped with a 5-meter-long hose. You only need to connect the water source interface. The power supply of the water spray test equipment is divided into 220V and 380V according to the different electrical equipment. The interface of the 220V power supply voltage can be directly connected to the daily power socket. The interface of the 380V power supply voltage is a three-phase five-wire interface, which needs to be strictly implemented according to the wiring standard. If it is connected incorrectly, it cannot be started, and the protection measures will prompt the phase sequence error.
2. Site: Water spray test equipment can generally be divided into box type and open type. The box type is not restricted by the site and can be used after connecting the water source and power supply. The open type needs to be waterproofed indoors, such as floor drains and drainage channels on the ground, waterproof coatings on the ground and walls, and waterproof electronic products (sockets, lighting, etc.) are used indoors.
3. Transportation: The appearance of the water spray test equipment is generally 1-1.4 meters wide. After purchasing the appropriate water spray test equipment, you should understand the appearance and dimensions of the water spray test equipment, and take relevant measures in advance in combination with the channel dimensions of the company's placement location. For example, if the laboratory door of an enterprise is 1.2 meters wide, and the width of the water spray test equipment is 1.3 meters, the door needs to be disassembled to enter.
4. Use space: Whether it is an open or box type water spray test equipment, after placement, the operator needs a certain amount of operating space after on-site operation. Therefore, 1-1.5 meters of space needs to be reserved at the door opening and debugging. Before placement, the company can refer to the space design drawing on the technical data.
Knowing the above requirements in advance can avoid the situation where the water spray test equipment cannot be used. Our sales and customer service staff will also communicate with you in advance.
Yuexin-focuses on the research and development and production of water spray test equipment, looking forward to every communication with you.
This article is an original article of Guangzhou Yuexin Testing Equipment Co., Ltd. and may not be reproduced without permission.
Your message must be between 20-3,000 characters!
