You may be unfamiliar with the hydraulic pressure tester. This is a popular name for the IPX8 waterproof tester in the environmental testing industry. Its detection principle is to pressurize water to simulate the water depth environment to perform IPX8 waterproof inspection on the product shell.
The hydraulic pressure tester is very simple to operate, and only 5 steps are required.
1. Connect the water source, power supply, and air source of the hydraulic pressure tester, loosen the bolts on the top, and add 3/5 of water to the tank.
2. Completely immerse the sample in water, and the height of the water surface does not exceed the overflow port.
3. Tighten the top bolts diagonally, and then close the manual exhaust valve.
4. Set the upper and lower pressure values on the Panasonic pressure sensor, and set the test time at the same time.
5. Manually adjust the intake pressure value to be greater than the upper pressure value set on the Panasonic pressure sensor.
6. Turn on the test power supply, and it will automatically stop and exhaust after the test is completed. When exhausting, you can open the manual exhaust valve to assist in exhausting.
According to the above-mentioned operation process of the hydraulic tester, an IPX8 waterproof test can be completed. At the same time, our company has found in communication with many companies that many new products need to be tested for IPX8 waterproof in actual application scenarios, such as requiring power-on inspection during operation and requiring synchronous data transmission during smooth operation.
Some companies also have requirements for the test water of the hydraulic tester, such as constant temperature control, water flow control, etc.
Yuexin-focuses on the research and development and production of hydraulic testers, and looks forward to every communication with you.
This article is an original article of Guangzhou Yuexin Testing Equipment Co., Ltd. and may not be reproduced without permission.
Your message must be between 20-3,000 characters!
